API MPMS 11.5.3:2009 pdf download

API MPMS 11.5.3:2009 pdf download.Manual of Petroleum Measurement Standards Chapter 11- Physical Properties Data Section 5- -DensityNWeightNolume Intraconversion Part 3- Conversions for Absolute Density at 15。C.
Implementation Guidelines
This revised standard is effective upon the date of publication and supersedes the applicable parts of API MPMS Ch.
11.1-1980, Volumes XI/XII. However, due to the nature of the changes in this revised standard, it is recognized that guidance concerning an implementation period may be needed in order to avoid disruptions within the industry and ensure proper application. As a result, it is recommended that this revised standard be utilized on all new applications no later than TWO YEARS after the publication date. An application, for this purpose, is defined as the point where the calculation is applied.
Once the revised standard is implemented in a particular application, the previous standard will no longer be used in that application.
However, the use of API standards remains voluntary and the decision on when to utilize a standard is an issue that is subject to the negotiations between the parties involved in the transaction.
I Scope
These intraconversion tables are applicable to all crude oils, petroleum products, and petrochemicals.
2 References
The following reference documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
API MPMS Chapter 11.1-2004, Temperature and Pressure Volume Correction Factors for Generalized Crude Oils, Refined Products, and Lubricating Oils
API MPMS Chapter 11.4.1-2003, Density of Water and Water VCFs for Volumetric Meter Proving
API MPMS Chapter 15-2001, Guideline for the Use of the International System of Units (SI) in the Petroleum and Allied Industries
ASTM Dl 250-1959 1, Report on the Development, Construction, and Preparation of the ASTM—IP Petroleum Measurement Tables
12th General Conference on Weights and Measures (1964)
NIST Handbook 44-2002 Edition 2, Specifications, Tolerances, and Other Technical Requirements for Weighing and Measuring Devices
NIST Handbook 44-2007 Edition, Appendix C
NIST Handbook 105-1 (Revised 1990), Specifications and Tolerances for Reference Standards and Field Standard
Weights and Measures
1 ASTM International, 100 Barr Harbor Drive, West Conshohocken, Pennsylvania 19428, www.astm.org.
2 National Institute of Standards and Technology, 100 Bureau Drive, Stop 3460, Gaithersburg, Maryland 20899, www.nist.gov.